video

sound

Persian Version

View:

1,087

Download:

0

Cites:

Information Journal Paper

Title

FABRICATION OF SECTIONAL COMPLETE DENTURE USING METAL FRAMEWORK DESIGN FOR A PATIENT WITH MICROSTOMIA: A CASE REPORT

Pages

  66-69

Abstract

 Microstomia is defined as an abnormally small oral orifice. MICROSTOMIA can occur as a result of trauma from electrical and thermal lesions, chemical burns and trauma from surgeries. Prosthetic rehabilitation of MICROSTOMIA patients presents difficulties at all stages, from the preliminary impressions to fabrication of prosthesis. For impression procedures different treatment methods have been suggested. Swing hinge and collapsible dentures are used to provide prosthodontic treatment to patients with MICROSTOMIA. Not only such a prosthesis is difficult to fabricate, but also may be expensive. The literature contains reports on the fabrication of sectional denture with the denture pieces connected by different designs. In this case, a new method of fabricating sectional complete denture for patient with MICROSTOMIA is introduced. This article describes a simple method of fabricating a 2-piece denture using removeable partial denture metal framework to connect the sections for a patient with limited oral opening. Combination of metal framework and sectional complete denture for a patient with limited oral opening is an acceptable, effective, and available method.

Cites

  • No record.

    • References

  • No record.

    • Cite

    APA: Copy

    ROHANIAN, A., & OMMATI SHABESTARI, GH.. (2010). FABRICATION OF SECTIONAL COMPLETE DENTURE USING METAL FRAMEWORK DESIGN FOR A PATIENT WITH MICROSTOMIA: A CASE REPORT. JOURNAL OF DENTAL MEDICINE, 23(1 (62)), 66-69. SID. https://sid.ir/paper/25821/en

    Vancouver: Copy

    ROHANIAN A., OMMATI SHABESTARI GH.. FABRICATION OF SECTIONAL COMPLETE DENTURE USING METAL FRAMEWORK DESIGN FOR A PATIENT WITH MICROSTOMIA: A CASE REPORT. JOURNAL OF DENTAL MEDICINE[Internet]. 2010;23(1 (62)):66-69. Available from: https://sid.ir/paper/25821/en

    IEEE: Copy

    A. ROHANIAN, and GH. OMMATI SHABESTARI, “FABRICATION OF SECTIONAL COMPLETE DENTURE USING METAL FRAMEWORK DESIGN FOR A PATIENT WITH MICROSTOMIA: A CASE REPORT,” JOURNAL OF DENTAL MEDICINE, vol. 23, no. 1 (62), pp. 66–69, 2010, [Online]. Available: https://sid.ir/paper/25821/en

    Related Journal Papers

    Related Seminar Papers

  • No record.

    • Related Plans

  • No record.

    • Recommended Workshops






    File Not Exists.