Click for new scientific resources and news about Corona[COVID-19]

Paper Information

Journal:   IRANIAN JOURNAL OF WOOD AND PAPER SCIENCE RESEARCH   spring 2018 , Volume 33 , Number 1 (62) ; Page(s) 63 To 75.
 
Paper: 

Investigating the possibility of particleboard manufacturing using Hemp stalk

 
 
Author(s):  HABIBI M.*
 
* Wood and Forest Products Research Division, Research Institute of Forests and Rangelands, Agricultural Research Education and Extension Organization (AREEO), Tehran, Iran
 
Abstract: 
The purpose of present study was the use of Hemp stalks for particleboard production. Mixtures of Hemp stalk and Eucalyptus wood at the ratios of 0: 100, 50: 50, 100: 0 were used. Also two resin content of 8 and 10% (based on oven dry weight of particle) and 2 press times of 3 and 4 minutes were employed for the production of laboratory particleboard. The properties of laboratory boards such as thickness swelling after 2 and 24 hours soaking in water, modulus of rapture, modulus of elasticity and internal bonding were measured and data were statistically analyzed. It was observed that the increase in Hemp stalk particles in the mixture resulted in increasing of bending properties (bending strength and modulus of elasticity) and thickness swelling after 2 and 24 hours water soaking. Also the results showed that higher ratio of Hemp stalk particles in the mixture resulted in reduction of internal bonding. As expected, physical and mechanical properties of particleboard improved with increasing resin content. Modulus of elasticity and thickness swelling after 24 hours water soaking were improved with increasing of press time. In general, comparing the produced board mechanical properties with standard of Iran requirements, the board produced using either 100% or 50% Hemp stalk, 8% resin content and 3 minutes press time showed that optimal properties. The failure of the physical properties of the boards to meet the standard values can be due to the lack of use of paraffin.
 
Keyword(s): Hemp stalk,eucalyptus,particleboard,bending strength,internal bonding
 
 
References: 
  • Not Registered.
  •  
  •  
 
Citations: 
  • Not Registered.
 
+ Click to Cite.
APA: Copy

HABIBI, M. (2018). Investigating the possibility of particleboard manufacturing using Hemp stalk. IRANIAN JOURNAL OF WOOD AND PAPER SCIENCE RESEARCH, 33(1 (62) ), 63-75. https://www.sid.ir/en/journal/ViewPaper.aspx?id=665354



Vancouver: Copy

HABIBI M.. Investigating the possibility of particleboard manufacturing using Hemp stalk. IRANIAN JOURNAL OF WOOD AND PAPER SCIENCE RESEARCH. 2018 [cited 2021July28];33(1 (62) ):63-75. Available from: https://www.sid.ir/en/journal/ViewPaper.aspx?id=665354



IEEE: Copy

HABIBI, M., 2018. Investigating the possibility of particleboard manufacturing using Hemp stalk. IRANIAN JOURNAL OF WOOD AND PAPER SCIENCE RESEARCH, [online] 33(1 (62) ), pp.63-75. Available: https://www.sid.ir/en/journal/ViewPaper.aspx?id=665354.



 
 
Persian Abstract Yearly Visit 51
 
 
Latest on Blog
Enter SID Blog