Click for new scientific resources and news about Corona[COVID-19]

Paper Information

Journal:   MODARES MECHANICAL ENGINEERING   MARCH 2017 , Volume 16 , Number 12 ; Page(s) 629 To 636.
 
Paper: 

EVALUATION OF SURFACE ROUGHNESS IN TURNING OF EPOXY-GLASS COMPOSITE TUBES

 
 
Author(s):  AZAD HASSAN MAJID, SHAKOURI EHSAN*, SARAEIAN PAYAM
 
* DEPARTMENT OF MANUFACTURING ENGINEERING, ISLAMIC AZAD UNIVERSITY- NORTH TEHRAN BRANCH, TEHRAN, IRAN
 
Abstract: 

Today, composite materials are used extensively in aerospace automotive and defense industries compared to metals, because of their high strength to weight ratio and good corrosive resistance.
Machining of these materials regard to their composite structure is complicated. Achieving optimal machining conditions, depending on the needs, requires proper analysis and careful investigation based on the type of fiber and resin used in composites. In this study, composite pipes made of glass-epoxy to a thickness of 5 millimeters, which are often used in the body of Aerospace structures, are produced by hand lay-up and their surface roughness is measured after turning process. In order to obtain the minimum roughness in the turning process, tool type in two modes, cutting speed, feed rate, and depth of cut are studied at three different levels. After the design of experiments with Taguchi method and tests on samples of pre-built, roughness measurements carried out surveys and analyzes. Finally, it is concluded that the minimum value of the surface roughness is obtained by tools with chip-breaking levels, cutting speed 100 m/min, feed rate 0.05 mm/rev, and the depth of cut 1.5 mm.

 
Keyword(s): SURFACE ROUGHNESS, EPOXY-GLASS COMPOSITE, TURNING
 
 
References: 
  • Not Registered.
  •  
  •  
 
Citations: 
  • Not Registered.
 
+ Click to Cite.
APA: Copy

AZAD HASSAN, M., & SHAKOURI, E., & SARAEIAN, P. (2017). EVALUATION OF SURFACE ROUGHNESS IN TURNING OF EPOXY-GLASS COMPOSITE TUBES. MODARES MECHANICAL ENGINEERING, 16(12 ), 629-636. https://www.sid.ir/en/journal/ViewPaper.aspx?id=573009



Vancouver: Copy

AZAD HASSAN MAJID, SHAKOURI EHSAN, SARAEIAN PAYAM. EVALUATION OF SURFACE ROUGHNESS IN TURNING OF EPOXY-GLASS COMPOSITE TUBES. MODARES MECHANICAL ENGINEERING. 2017 [cited 2021August02];16(12 ):629-636. Available from: https://www.sid.ir/en/journal/ViewPaper.aspx?id=573009



IEEE: Copy

AZAD HASSAN, M., SHAKOURI, E., SARAEIAN, P., 2017. EVALUATION OF SURFACE ROUGHNESS IN TURNING OF EPOXY-GLASS COMPOSITE TUBES. MODARES MECHANICAL ENGINEERING, [online] 16(12 ), pp.629-636. Available: https://www.sid.ir/en/journal/ViewPaper.aspx?id=573009.



 
 
Persian Abstract Yearly Visit 35
 
 
Latest on Blog
Enter SID Blog