Paper Information

Journal:   JOURNAL OF FACULTY OF ENGINEERING (UNIVERSITY OF TABRIZ)   FALL 2006 , Volume 33 , Number 2 (44 MECHANICAL ENG.); Page(s) 43 To 47.
 
Paper:  DYNAMIC ANALYSIS OF CARDAN JOINT IN DIFFERENT ANGELS OF OUTPUT AXLE OF TRANSMISSION, ENTRANCE AXLE OF DIFFERENTIAL AND CARDAN SHAFT AXLE
 
Author(s):  ESLAMIAN MOSTAFA*, SADEGHI MORTEZA, PIREH H.
 
* MECHANICAL ENGINEERING DEPARTMENT, UNIVERSITY OF TABRIZ
 
Abstract: 

The experience has shown that the reaction of cardan joint in different angles of axis installation is different. Cardan joint fails more due to yoke bending and the failure of cross trunnion is more in the form of galling of end surfaces, the spalling and brinelling of trunnion. In this research we have tried to study the effect of different angles of input flange yoke (the angle of output axle of transmission), output flange yoke (the angle of input axle of differential) and cardan shaft axle subject to the forces of cardan connective parts. Considering all analysis we conclude that reducing the installation angle of driveshaft, will cause in reducing of number of cycles 'of forces developed in cardan elements. Comparison of the results between two models (in the first model, the cross element and the input flange yoke have the same angle of setting that in the second model, the setting angle of cross element is the same as that of output flange yoke) shows that the curves of forces in the second model are more uniform with less fluctuations.

 
Keyword(s): DYNAMIC ANALYSIS, JOINT ANGLE, DRIVELINE, FLANGE ANGLE, MOVEMENT ANALYSIS
 
References: 
  • ندارد
 
  Persian Abstract Yearly Visit 29
 
Latest on Blog
Enter SID Blog